If the lock is set to the factory shipping combination, use this procedure: 2. A new combination should be set before the lock is used. Meets Federal Specification FF-P-110 All new 8077 locks are shipped from the factory set to a single combination number of 25. Turn the dial left (counterclockwise) until the first number of the combination aligns with the opening index the fourth time. If the lock is new and is just being put into service, its combination is set to the single number 25. Sargent & Greenleaf Introduces Revolutionary New I. Turn the dial right (clockwise) until the second number of the combination aligns with the opening index the third time. Non-deadlocking spring bolt model is designed for lightweight and inner compartment doors that require the lock to latch and secure the PO Box 930, Nicholasville, Kentucky 40340-0930 USA Phone (859) 885-9411 Phone (800) 826-7652 FAX (859) 887-2057 FAX (800) 634-4843 Sargent & Greenleaf S. On the fourth revolution, align the number 25 on the dial with the padlock's opening index. Turn the dial counterclockwise four complete revolutions. Before attempting to change the combination, you should be thoroughly familiar with the opening procedure. 8077AC - Black Dial 8077AD - Black Dial 8077 - Green Dial 8077A - Green Dial 8077AB - Green Dial Before attempting to operate the lock, study the illustrations and familiarize yourself with the names of the various parts of the padlock. Turn the dial left until the third number of the combination aligns with the opening index the second time. Turn the dial clockwise to align zero with the padlock's opening index. Pull sharply on the shackle to open the lock. Failure to do this could cause difficulties in opening the lock. Warranty When opening the lock or changing the combination, care should be taken to very precisely align the numbers of the combination and the index. Turn the dial right until zero is aligned with the opening index the first time. This lock is guaranteed to be free of defects in materials and workmanship for a period of one year. For instance, you should try dialing to 24½ or 25½. For additional dialing tips, visit S&G's website, at: Note: If the lock fails to open, dial ½ number lower or higher to compensate for possible variation of the factory setting. Look for "8077 Dialing Tips" in the Support section. Contact S&G for a Return Goods Authorization (RGA) or technical assistance at 85, or FAX S&G at 80. We will repair or replace, at our option, any lock which proves to be defective within the one year warranty period, providing it is returned to our factory. OPENING INDEX CHANGING INDEX SHACKLE Important: After re-locking the padlock, the dial must be turned at least five complete revolutions in either direction to ensure the mechanism is fully locked. Figure A Copyright 2004, Sargent & Greenleaf, Inc.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |